Expert Yogi
Posts: 8285
    
| Disassembly and assembly steps of horizontal clean water centrifugal pump
The centrifugal pump needs to pay attention to maintenance, which requires the operator to be very familiar with the water centrifugal pump, not only to have rich maintenance experience, but also to understand the working principle, disassembly, maintenance, installation, etc. of the centrifugal pump. The following is the removal and installation procedure of horizontal water centrifugal pump.
Disassembly and assembly steps of horizontal clean water centrifugal pump:
Before the installation of horizontal centrifugal pump, first check whether the parts are bumped and worn, clean them, and then assemble them.
(1) First, tighten the connecting bolts and plugs on the corresponding parts.
(2) Place the O-ring, paper pad, felt, etc. on the corresponding parts.
(3) First, install the seal ring, packing ring, packing ring, packing gland, etc. into the pump cover in turn.
(4) Install the rolling bearing on the shaft and then on the suspension, close the gland, press down the rolling bearing, and sleeve the connecting bolt on the shaft.
(5) Install the shaft sleeve on the shaft, and then install the pump cover on the suspension. Install and tighten the impeller, stop washer, impeller nut, etc. Then assemble the above accessories into the pump, and tighten the connecting bolts on the pump body and pump cover.
In the above installation process, the components that are easy to be ignored, such as O-ring, flat key and water retaining ring, can be put into the sealing bag.
From step (5) to step (1), the disassembly sequence of the horizontal clean water centrifugal pump can be reversed.
Water Ring Vacuum Pump Of Repairing The Worn Bearing Position Of Attention Should Be Paid To The Details |
Disassembly and assembly steps of horizontal clean water centrifugal pump
