Expert Yogi
Posts: 8285
    
| How to deal with the blockage of sewage pump? Cold water should be used to cooperate with solvent for cleaning. If the blockage is relatively serious, the human resources will be connected after the pump body is disassembled and disassembled. Frequent disassembly of the pump will accelerate the damage of relevant components of the pump mouth ring. Therefore, it is necessary to avoid blockage as much as possible. In the process of operation, the following common problems can be used to reduce the blockage of the sewage pump.
After knowing how to deal with the blockage of the sewage pump, it is very necessary for the operators of machinery and equipment to apply appropriate maintenance methods to reduce the probability of blockage of machinery and equipment. As long as it is a sewage pump with qualified quality, there is very little blockage when solving the wastewater matching the specifications. The blockage is usually caused by the untimely daily maintenance. For example, if the pump is not cleaned immediately after the wastewater with high liposuction viscosity, the material will inevitably solidify over time, causing the centrifugal impeller of the pump to be stuck and blocked.
In order to better reduce this situation, customers must formulate timely maintenance and repair plans according to the application of sewage pumps and well-known brands, so as to lubricate the grease on time and ensure the actual effect of the lubrication of machinery and equipment. At the same time, the internal parts such as gear rack, centrifugal impeller, rolling bearing, piston rod, etc. should be inspected, the brittle or seriously damaged parts should be replaced immediately, and the hydraulic machine should be cleaned. In addition, before using the sewage pump and placing it for a long time, it must be operated in the sewage well for several minutes to achieve the actual effect of high-pressure cleaning of the pump chamber.
On the whole, the operators should be more concerned about how to deal with the problem of sewage pump blockage. It is generally proposed to assign full-time personnel to supervise and manage the sewage pump in the whole process, and regularly maintain the winding resistance of the submersible pump and the grounding resistance in the middle of the shell. Every 400 hours, the automobile oil in the grooves is removed and replaced up and down, especially the value traceability of the sealing ring between the centrifugal impeller and the pump housing. If it is a deep submersible sewage pump, it must be removed from the water in the future when it is not easy to reuse, so as to reduce the opportunity of motor rotor winding resistance and moisture return.
After the detailed introduction of the above content, I firmly believe that you also have a detailed understanding of how to deal with the blockage of the sewage pump. You only need to select the sewage pump with matching characteristics according to the specific working conditions and transported substances, and the blockage condition is very rare
vacuum unit in installing spring device of significance |
How to deal with the blockage of sewage pump
