YogiSource.com my account | view cart | customer service
 Search:    
Welcome to the new Yoga.com Forums home!
For future visits, link to "http://www.YogiSource.com/forums".
Make a new bookmark.
Tell your friends so they can find us and you!

Coming soon ... exciting new changes for our website, now at YogiSource.com.

Search | Statistics | User Listing View All Forums
You are logged in as a guest. ( logon | register )



Hydraulic motor disassembly steps
Moderators: Moderators

Jump to page : 1
Now viewing page 1 [25 messages per page]
View previous thread :: View next thread
   Yoga -> General YogaMessage format
 
hhm1020
Posted 2020-07-03 6:18 AM (#255872)
Subject: Hydraulic motor disassembly steps


Expert Yogi

Posts: 8285
500020001000100100252525
Hydraulic motor disassembly steps
The clearance of each moving pair of hydraulic motor from the factory has been well matched, and the user is not allowed to change parts casually. In general, do not open the motor at will, only in the case of serious failure, we need to agree with the company to open the inspection.
(1) Preparation before opening

Remove the drain plug and drain the oil from the motor housing.

Loosen 5 screws on the pan and remove the pan.

Take out the oil distribution pan, positioning ring, pad, cylindrical pin and double-headed key.

Note: In order to prevent the change of backward rotation in the reassembly, the marks of the same square shall be made on the end face of the output shaft and the oil distribution plate surface.
(2) Sequence of disassembly and installation

Remove the cover, screw the clean screw into the center screw hole of the crankshaft, and lift out the crankshaft.

Remove the clamping ring on the connecting rod.

3. Take out the connecting rod components of the plunger body, and make corresponding marks one by one, so as to ensure the original assembly clearance during reassembly. If necessary, the combination of the plunger body and connecting rod can be decomposed again: loosen the hole with the spring retaining ring, take out the retaining ring, and the plunger body and connecting rod can be separated.

4. Assemble according to the opposite procedure above, and pay attention to ensure the axial clearance of the bearing.

All parts must be cleaned before assembly to prevent scratch or scratch any working surface.

If there is only oil leakage in the sand hole of the plunger sleeve or oil leakage in the joint surface of the plunger sleeve and the shell, loosen the screws on the plunger sleeve, remove the plunger sleeve, and replace the plunger sleeve or "O" ring.
Related products:
Ultrafiltration System For Water Purification
Fully Automatic Water Softener


Other related products:
Vacuum pump price list

Basic vacuum pump selection

Vacuum pump selection

Vacuum pumps types of industrial


Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [25 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread


(Delete all cookies set by this site)